[Dialer slitaz]
Init2 = ATQ0 V1 E1 S0=0 &C1 &D2
Modem Type = Analog Modem
; Phone =
ISDN = 0
; Username =
Init1 = ATZ
; Password =
Modem = /dev/ttyUSB0
Baud = 9600
wvdialconf
sed -i "s/ttyACM/ttyUSB/" /etc/wvdial.conf
sed -i "s/rfcomm/ttyUSB/" /etc/wvdial.conf
cat /proc/net/dev | grep eth, i have not investigate it. I'm used to wicd for eth* or wireless and typing wvdial in a console for ppp.
--> WvDial: Internet dialer version 1.41
--> Initializing modem.
--> Sending: ATZ
ATZ
OK
--> Sending: ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
OK
--> Modem initialized.
--> Sending: ATDT #777
--> Waiting for carrier.
ATDT #777
CONNECT
--> Carrier detected. Starting PPP immediately.
--> Starting pppd at Tue Mar 16 19:46:00 2010
modprobe cdc-acm
rm /etc/wvdial.conf
tazhw box
echo debug >> /etc/ppp/peers/wvdial
ifconfigto see if ppp0 is up, the interface of tazhw does not show you clearly that ppp is up.
modprobe cdc_acm
[Dialer Defaults]
Modem = /dev/ttyACM0
Baud = 460800
Init1 = ATZ
Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
Carrier Check = yes
Dial Command = ATDT
Phone = #777
Username = your cricket number goes here
Password = Cricket
Stupid Mode = yes
Auto Reconnect = yes
root@slitaz:/home/tux# route
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
10.6.6.6 * 255.255.255.255 UH 0 0 0 ppp0
127.0.0.1 * 255.255.255.255 UH 0 0 0 lo
default * 0.0.0.0 U 0 0 0 ppp0
It looks like you're new here. If you want to get involved, click one of these buttons!