I have been trying to get my wireless interface running with no luck.

Followed the instructions I found elsewhere on this forum:
- installed b43-firmware and b43-fwcutter
- installed linux-wireless
- loaded the driver through wifibox
- lsmod shows the b43 module loaded
- edited network.conf to activate wifi at boot

But I don't see any networks in the list nor does iwconfig show any wireless extensions. Any direction would be very helpful. Thanks.

I did notice the following in dmesg:

udev: starting version 150
HDA Intel 0000:00:1b.0: PCI INT A -> GSI 22 (level, low) -> IRQ 22
HDA Intel 0000:00:1b.0: setting latency timer to 64
b43-pci-bridge 0000:03:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17
b43-pci-bridge 0000:03:00.0: setting latency timer to 64
ssb: Sonics Silicon Backplane found on PCI device 0000:03:00.0
cfg80211: Using static regulatory domain info
cfg80211: Regulatory domain: US
(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
(2402000 KHz - 2472000 KHz @ 40000 KHz), (600 mBi, 2700 mBm)
(5170000 KHz - 5190000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
(5190000 KHz - 5210000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
(5210000 KHz - 5230000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
(5230000 KHz - 5330000 KHz @ 40000 KHz), (600 mBi, 2300 mBm)
(5735000 KHz - 5835000 KHz @ 40000 KHz), (600 mBi, 3000 mBm)
cfg80211: Calling CRDA for country: US
b43-phy0: Broadcom 4312 WLAN found (core revision 15)
b43-phy0: ERROR: FOUND UNSUPPORTED PHY (Analog 6, Type 5, Revision 1)
b43: probe of ssb0:0 failed with error -95
Broadcom 43xx driver loaded [ Features: PL, Firmware-ID: FW13 ]